It is built in scale 1/10. And the weight is only 450 grams.
This MOC is based in the small French buggy AXR 400.
The final size is 30x18x15 studs.
It uses a PF M motor for steering, with auto-center.
For drive it has a PF L motor, it it can use a M if you want.
You can change easily the gear ratio between: 1:3(8kph), 1:1.67(4.5kph) or 1:1(2.7kph).
The suspension is independent in the front axle, and a pendular axle in the back.
As always a little video:
Finally you can download the complete instructions in the INSTRUCTIONS page, enter and access to the Download folder
31 comments:
Thank you for the instructions.
Hi dear, thank you by your instructions share and congratulations for such simple design and so nice MOC!
can you use it for hill-climp ?
How can i make a part list and buy on bricklink?
Thanks for the instructions!
V1 or V2 receiver
It doesn't mutter, it will work find with both.
Thanks but can it go any faster then this?
Yes, the differnce between V1 and V2 are only under high load, with only one L motor, you should see any difference
Thanks and i saw on youtube that a v2 and a rc-motor can hurt a 9volt bb-box can it hurt the one you use too. And do you meen should or should't.
Ups, sorry: "you shouldn't see any difference"
How long will it drive and did you ever has a engine-failure no matter wich moc's you mean
Are you going to make more video's? Just for fun.
The last Anonymous is right when will you make more videos from this car?
I only make one video for each car. The reason is very simple: I don't like make videos. I make them only because they are necessay to show my work but I don't like it. :(
I have notice a problem with the front supspension the wheels hit the fenders.Is it able to fix it?
Just try...
Ok just try i found something instead of using the standard fenders i use curved-liftarms maybe you should try it too.
Looks like it`s fun to drive it :D Nice!!
Can you put up some photos of the steering on the AXR 400 Crossbone ,love the creation, so cool!
I downloaded your instructions and they are very much out of order and I can not understand them at all. If you could make me one and have it shipped to me and I could pay you for it that would be very appreciated.
I also thought the instructions were hard to under stand. there are a some pieces that I don't have can i by them from you
I don't sell parts. Try in bricklink.com
Why not use a servo motor for steering?
Easy: cost. A servo motor is 3 times more expensive than a M motor.
That's good to know I almost bought a servo
Hey I had a quick question. So I am about to purchase this, but how would I steer it, and what gears would I need for it to go at 5 mph? Otherwise, I loved this MOC
To steer it uses a PF M motor. To go as fast as possible you need 24:8 gears
Thanks for the quick response :)
I meant to ask how I can control the Buggy once I have made it?
Using the LEGO PF remote controller
Post a Comment